- Mouse Mod :
- Disassembly :
- LED Removal :
- 1st LED install :
- 2nd LED install :
- Reassembly :
- Testing :
Mouse Mod - 2nd LED Install
To add the second LED, snip it's leads to about 3/4 of an inch long.
;)
Now bend itty-bitty right angles at the ends.
You're going to use needle-nose pliers to crimp the leads of the 2nd LED around the leads of the first one.
;)
Check the alignment of the LED (it's the same as the first one) and use your pliers to crimp the ends of the second LED around the first Then solder the leads together on each side.
At this point grab that glue gun and dab a bit of glue to the base of the leads for strength.